Thread: Exhibit your Custom Case Work.

I haven't actually done much of anything but add the red or green led fans and 9"blue neon, so far-when my novel processor arrives I acquired a cooler master jet 4 hs/fan, and might be cutting in a fan it the top, I'll post those pics in a couple weeks, but here it is so far

This is my home-built case. I call it the Breadbox. I produced the cover for the PSU & air filter out of few scrap stainless. I packed the PSU out of care that the hard-disk was thus close to it. I don't experience if it's actually required but I don't have any EMF data corruption troubles. The filter is for a lawnmower, had to cut the paper away because it is WAY also limiting. The rubber seal with the top is cut from a garage door bottom seal. The drive amounts are plumbing pipe hangers.