Thread: PC boots up but no picture

Hi, so we PC the Works and also a standard monitor. All connected, no image so seem to work all that noise technically. Monitor brings just the usual picture, no signal. now have the video card is removed and replaced by another. Works but no more but have no other PC where I could test the normal graphics card. Well now we know further had one probably good if someone could help LG.

Apparently not or? First of all it would be good to know about what hardware it is name precisely as possible each part not forgetting the second graphics card. Without going but knowing too much I had either tap the power supply which weakly to is supplied to the graphics cards to provide sufficient power or PCI-E slot on the motherboard which may be defective.

Thanks for the quick reply. Well the office work So when new items it seeming to as inputs everything. The hard drive is working, and the rest stop also. The Pc was just it otherwise perfect, only for 2 days not anymore Rebuilt was nothing. It is AMD likely a 5800 + be 2x Samsung 2GB memory has DDR2 Has ne GeForce 9400 GT, 5120 mb Motherboard Am2 + PSU 500w if I correctly interpret the other graphics card is old ATI 9200SE 128 mb ddr pci As I said the Pc was normal. Achso and chilly paste HPs we changed but because nothing went wrong and the chip is seated properly in it again.

Well, if you take out the 9400GT and 9200 to plug into a standard PCI slot it should work anyway attempt best you raise another PC to test the graphics card there. Function when it is probably most likely the motherboard have a quirk. You could still test each one in different Ramriegel Ram slots. Provided that leads to nothing and I would resort to zero method. Everybody out except the power supply, the motherboard, the CPU and the graphics card and Rampage because I would suggest you take her first to use the old 9200 and of course a PCI slot would be important to know if you are unable to get a beep and what you get when you use the null method. By the way this is not a cooling paste but only heat conductive paste, and it should apply only spread so much and that the CPU heat spreader still easily shine through and be seen in some places is.

Tried everything leads to no result. The pc beeps unfortunately no net even without ram bolt and the thermal grease is applied even thinner than encouraging picture and I am so wirds on my own pc then also always made it can therefore hardly. I am just unfortunately net here

Since I would certainly tap the motherboard. Power the parts do receive but the infrastructure is almost damaged. The mainboard does not get it that is missing and therefore no sound. said, a computer would be so with the same base the best solution. There you could test each part. When all parts of PC1 in PC2 function the parts of PC2 but not on the main board of PC1 should be clear what hardware has a way. Would you be proposing myself two motherboards depending on whether you ATX is a or ATX model need.

Could it also be the CPU, take her to get out and use them again. Test times without any consumer so dress once from the hard drive and the other drives so that you have connected only motherboard, CPU, graphics card and RAM. The further you can sometimes take out bios battery and after 5 minutes and then again reinsertion testing. I know not now what you have for a motherboard but exclude some of your PC boxes and turn on the PC some motherboards give an error message about language.