Hello all
BP of the failure num is actually the room is glass or the reflector lamp blackened on the outside edge (not shrunk). To fix this 1 / remove the top of the printer.
Hello all
BP of the failure num is actually the room is glass or the reflector lamp blackened on the outside edge (not shrunk). To fix this 1 / remove the top of the printer.
Impeccable, a good cleaning glass + a good shot of white correcting the white plastic reflector (which seems to shrink, revealing the black plastic underneath) and go again like in 40!
I followed your instructions with great success! I could not believe it at first but it worked very well. Remove the small screws was complicated because they are starry and I had no compatible driver. I persisted in using a small screwdriver, square head.
Also, in the final stages, I had no white correction fluid. But I could remove the white plastic strip from container and aluminum back. The black appeared only on one side. The longest was to reinsert the tape. Initially, I rolled around a small wooden stick to push it, but in the last few millimeters, it did not work.
There are currently 1 users browsing this thread. (0 members and 1 guests)